Alabama pricing
Air Duct Replacement Cost Calculator — Alabama
Estimate duct replacement cost from your home's size, run count and how hard the attic or crawlspace is to work in. Every figure below is already adjusted for Alabama labor and material pricing.
Model reviewed August 2026
Does ductwork replacement cost cost more in Alabama?
-10% versus the national baseline
Installed prices in Alabama run about 10% below the national baseline. Permit fees are about 15% lower than the national average. Homeowners may generally permit work on a home they own and occupy, subject to local rules.
Coastal Baldwin and Mobile counties enforce wind-borne debris requirements that inland Alabama does not, which changes roofing and window pricing sharply within one state.
Compare with the national average ductwork replacement cost calculator.
Estimated total cost
$6,386 – $9,069
- Cost per square foot
- $4
- Cost per supply run
- $725
Estimates only. Local pricing, site conditions and code requirements change the real number.
What changes the number in Alabama
| Local cost indexBelow the national baseline | 0.90x national |
|---|---|
| Permit fee index | 0.85x national |
| Code basisAdopted locally | Local adoption of the IRC; statewide code applies to state-funded and manufactured housing |
| Owner-builder posture | Homeowners may generally permit work on a home they own and occupy, subject to local rules |
| Largest markets | Birmingham, Huntsville, Montgomery, Mobile |
The formula
Cost = (sq ft x rate) + (runs x per-run cost) x access multiplier + permit
Duct replacement is priced mostly by labor hours. Tight crawlspaces and low attics can add 30–50% over an open, walkable space.
Covered markets in Alabama
City-level cost and permit pages with local building department links.
Frequently asked questions
How much does it cost to replace ductwork?
Whole-home duct replacement usually runs $3,500 to $12,000 in 2026, or roughly $2 to $4 per conditioned square foot.
Should I replace ducts with the HVAC system?
If ducts are over 20 years old, undersized or badly leaking, doing both at once saves labor and protects the new system's efficiency rating.
Sources
Sources & verification
- Alabama Building Commission
- ENERGY STAR sizing and efficiency guidance
- ACCA Manual J / Manual S sizing standards
- AHRI equipment performance directory
- International Code Council (IRC/IBC)
Model vintage August 2026. The links above are the issuing agencies' own pages — we publish them so you can confirm the current rule yourself, not as evidence that each fact on this page was re-checked with them today. Cost figures are modeled estimates based on national baselines adjusted for local labor and material pricing, not quotes. Permit rules change; confirm with the building department before starting work.