AC Replacement cost in Fort Worth, TX
Fort Worth, TX · updated August 2026
$8,800
Typical local cost
$5,100 – $15,300
Typical range
- per ton of cooling capacity
- $1,600 – $3,150
- Permit
- Yes
- Typical timeline
- 1 day of work
Installed, local pricing
$90 – $325 in fees
1 day of work, 1-3 weeks including permit and inspection
Fort Worth runs -1% against the U.S. average · data confidence High · modeled estimate, not a quote
Most Fort Worth homeowners pay around $8,800. The local adjustment for this trade is x0.990 — driven mainly by Tarrant County labor rates and 55% exposure to local code requirements.
Estimate your Fort Worth job
Priced with this market's cost index, so the calculator, the size table and the ranges on this page all agree.
Recommended size
5 tons
Round to the nearest half ton
- Cooling load
- 61,000 BTU/hr
- Typical equipment costInstalled, 14-17 SEER2
- $8,075 – $15,200
- Rule-of-thumb check
- 400 sq ft per ton
Estimates only. Local pricing, site conditions and code requirements change the real number.
Cost by project size
Generated from the same unit pricing the calculator uses.
| Project size | Estimated range |
|---|---|
| 2 ton of cooling capacity | $3,200 – $6,300 |
| 3 ton of cooling capacity | $4,800 – $9,500 |
| 4 ton of cooling capacity | $6,400 – $12,600 |
| 5 ton of cooling capacity | $8,000 – $15,800 |
| 6 ton of cooling capacity | $9,600 – $18,900 |
Based on Fort Worth pricing of $1,600–$3,150 per ton of cooling capacity.
Cost by system scenario
Equipment type, tonnage and whether the ductwork or electrical has to change move HVAC pricing more than brand does. Every row is priced against the Fort Worth median.
| Scope | What it includes | Typical installed cost |
|---|---|---|
| Straight equipment swap | Same tonnage, existing ducts and pad reused | $6,200 – $8,400 |
| Higher-efficiency replacement | Upgraded SEER2 tier, same configuration | $8,400 – $11,000 |
| Heat pump conversion | Electric heat pump replacing AC plus furnace or strips | $9,700 – $13,200 |
| Replacement with duct repair | Sealing, resizing or replacing failed duct runs | $11,000 – $15,000 |
| Ductless multi-zone | Three to four indoor heads, new line sets | $10,600 – $15,000 |
- • Correct sizing comes from a load calculation, not from matching the old unit's tonnage — an oversized system short-cycles and costs more to run.
- • Line-set replacement and electrical disconnect work are common add-ons on a swap that was quoted as straightforward.
- • Refrigerant transition rules mean older-refrigerant equipment is no longer a like-for-like replacement in most markets.
Basis: Each scope is priced as a multiple of the modeled Fort Worth median for ac replacement, so the scenarios, the size table and the calculator always agree. · Hometriva methodology
Cost by material
Installed cost in this market, with expected service life.
| Material | Installed range | Lifespan | Maintenance |
|---|---|---|---|
| Heat Pump System | $7,900 – $12,300 | 12–18 yrs | Moderate |
| Central AC + Gas Furnace | $7,000 – $11,400 | 15–20 yrs | Moderate |
Where the money goes
- Labor
- $4,000
- 44% of median
- Materials
- $4,800
- 53% of median
- Permit & fees
- $210
- 2% of median
Fort Worth project costs-1% vs U.S. average
Based on Tarrant County labor rates, local material logistics and permit-fee posture for this trade.
What the project looks like start to finish
Typical sequence for this scope. Timing varies with contractor backlog and plan-review queues.
01
Planning & quotes
Scope, material choice, contractor selection
02
Permit application
Filed with City of Fort Worth building department
03
Materials & staging
Order lead time on non-stock materials
04
Installation
1 day of work, 1-3 weeks including permit and inspection
05
Inspection
Mechanical rough / equipment set, Electrical disconnect, Final mechanical inspection
06
Closeout
Final sign-off, warranty and documentation
Fort Worth labor intelligence
What the trade charges here, and how much of your price it is.
Loaded hourly rate
$79–$103
HVAC crews in Tarrant County · -5% vs U.S. ($95/hr)
Typical crew
3 × 2 days
On-site time for a typical ac job here.
Labor in the price
$4,000
45% of the median — the rest is material, disposal and permit.
Because labor is 45% of this job, Fort Worth wage levels move the price far more than material prices do. A quote well under this labor figure usually means a smaller crew, a longer schedule, or unlicensed help.
Basis: Hometriva labor model: national hvac crew rates adjusted by the Tarrant County labor factor (x0.948). · BLS Occupational Employment and Wage Statistics, Hometriva methodology
Why Fort Worth differs from the national average
The local delta, broken into dollars by driver.
Code and inspection load+$225
AC Replacement carries 55% exposure to local code requirements, and this jurisdiction's review load indexes at x1.04.
Trade labor rates-$200
Tarrant County crews price 5% below the national average, and labor is 45% of this job.
Material and delivery-$100
Materials are nationally traded, so they move less — but delivery into this market runs 2% under baseline.
Basis: Decomposition of the modeled Fort Worth median against the U.S. median for this scope. · City of Fort Worth building department, Hometriva methodology
Fort Worth vs Texas vs the U.S.
Change the inputs, see your number
The same local model, run against your job instead of the average one.
Simulated ac replacement in Fort Worth
$9,010
Likely range $5,310 – $15,510
Simulated from the same local model as the numbers above — it changes the inputs, not the pricing method.
What makes the number move
- System size in tons and SEER2 efficiency rating
- Heat pump versus straight cool with electric heat
- Air handler location (attic, closet, garage)
- Duct condition and any required duct replacement
- Electrical upgrades and new disconnect
Who issues each permit
Tracked per discipline — the building permit issuer is not always the body that reviews electrical, plumbing, zoning or fire.
| Discipline | Issuing authority |
|---|---|
| building | City of Fort Worth building departmentModeled estimate |
| electrical | City of Fort Worth building departmentModeled estimate |
| mechanical | City of Fort Worth building departmentModeled estimate |
| plumbing | City of Fort Worth building departmentModeled estimate |
| zoning | City of Fort Worth building departmentModeled estimate |
| fire | City of Fort Worth building departmentModeled estimate |
Permit requirement in Fort Worth
Yes — a permit is required for ac replacement in Fort Worth, TX. The work must be inspected before it can be closed out, and a licensed contractor generally has to pull the permit.
- Permitting authority
- City of Fort Worth building departmentModeled estimate
- Permit fee
- Estimated allowance $90–$325Modeled from comparable fee schedules — not an official quoted fee.
Inspections
- Mechanical rough / equipment set
- Electrical disconnect
- Final mechanical inspection
Local conditions that change this job
Only the exposures that materially affect ac replacement.
Cooling load / heat exposure
Severe88/100
Humidity
Moderate58/100
Solar irradiance
Severe82/100
Same hail belt as Dallas with a higher owner-occupancy share, which pushes more full replacements through insurance claims.
Nearby market comparison
| Market | Local factor | Median | Per ton of cooling capacity |
|---|---|---|---|
| Fort Worth (this page) | x0.990 | $8,800 | $1,600 – $3,150 |
| Dallas | x1.013 | $9,000 | $1,600 – $3,250 |
| Austin | x1.102 | $9,800 | $1,750 – $3,550 |
| Oklahoma City | x0.925 | $8,200 | $1,500 – $2,950 |
What Fort Worth homeowners actually paid
Real reported invoices from this market, aggregated. Add yours — it takes 20 seconds and no personal details.
Quotes homeowners were given in Fort Worth
Quotes run ahead of final invoices. Reporting yours shows the local spread and where there is room to negotiate.
How Hometriva estimates Fort Worth ac costs
Hometriva does not publish invented city prices. The Fort Worth estimate for ac replacement is produced by this chain, and every input is stored separately:
- National baseline$8,900
Typical U.S. cost for ac replacement on a single-family home.
- Local labor factorx0.948
Fort Worth-area trade labor rates, weighted at 45% of this job.
- Material factorx0.981
Material and delivery pricing into Tarrant County, weighted at 55%.
- Regulatory factorx1.045
Local code, product-approval and inspection load, applied at 55% for this project type.
- Applied multiplierx0.990
Blended Fort Worth adjustment specific to ac replacement.
- Permit component$90 – $325
Budgeted separately from the contract price because it is paid to the jurisdiction.
Because labor, material and regulatory factors are weighted per project, ac replacement in Fort Worth carries a different local adjustment than other trades in the same market.
Reviewed by
Hometriva Cost Data Desk
Maintains the unit-cost baselines, local adjustment factors and material pricing. Reviewed for ac replacement pricing in Fort Worth, TX.
- • National unit-cost baselines against current trade pricing
- • Local labor and materials factors for the market
- • Material installed-cost ranges and service life
Last reviewed August 2026 · Editorial standards · Report an error
Frequently asked questions
Do I need a permit to replace an AC unit?
Yes. A mechanical permit is required for a residential air conditioner changeout in every Florida jurisdiction, and the work must be inspected. Licensed HVAC contractors pull this permit as part of the job.
What size AC do I need in Florida?
A rough Florida rule of thumb is one ton of cooling per 500-600 square feet of conditioned space, but proper sizing uses a Manual J load calculation that accounts for insulation, window area, orientation and ceiling height. Oversized systems short-cycle and fail to remove humidity.
How long does an AC last in Florida?
Because systems run nearly year-round and coastal salt air accelerates corrosion, Florida air conditioners typically last 10-15 years versus 15-20 in cooler climates.
Sources
Sources & verification
- City of Fort Worth building department
- Fort Worth permit portal
- Texas Department of Licensing and Regulation
- BLS Occupational Employment and Wage Statistics
Last verified August 2026. Cost figures are modeled estimates based on national baselines adjusted for local labor and material pricing — they are not quotes. Permit rules change; confirm with the building department before starting work.